2010 Cadillac CTS Sedan AWD V6-3.6L Technical Service Bulletin # 09-08-48-001B Date: 110607
Audio System - Reduced AM/FM Station Reception
TECHNICAL
Bulletin No.: 09-08-48-001B
Date: June 07, 2011
Subject: Reduced AM and/or FM Station Reception (Remove/Clean Urethane from Glass or Replace Rear Window)
Models:
2008-2011 Cadillac CTS, CTS-V
..........................................................................................................................................................................................................................................
Supercede:
This bulletin is being revised to add the 2011 model year. Please discard Corporate Bulletin Number 09-08-48-001A (Section 08 - Body and
Accessories).
..........................................................................................................................................................................................................................................
Condition
Some customers may comment about reduced AM and/or FM radio reception.
Cause
This condition may be caused by urethane and/or urethane primer that is too close to, or extends over, the silver printed antenna on the rear window
glass.
Correction
Important
Perform the following inspection and repair before re-seating any connections associated with the antenna/radio system and
removal/replacement of the antenna modules, radio unit (including coaxial cables, power signal, and ground wires).
1. Remove the necessary trim to access the rear window glass perimeter. Refer to Quarter Upper Trim Panel Replacement and Rear Window
Panel Trim Replacement in SI.
2010 Cadillac CTS Sedan AWD V6-3.6L Page 132
2. Inspect the glass antenna perimeter. The minimum clearance for the urethane/primer to any silver antenna printing on the surface of the glass
must be 11 mm (0.43 in) or greater. If the urethane/primer extends over the silver antenna printing (1), replace the glass. Refer to Rear
Window Replacement (Sedan) is SI.
Important
Use extreme caution when eliminating the excess urethane/primer from the glass. Tape the silver antenna printing on the glass with
blue painter's tape. Care must be taken not to damage, cut or scrape any of the silver antenna printing or blackout on the glass, as
well as not to damage/disrupt any electrical connections attached to the glass.
3. If the urethane/primer does not extend over the silver antenna printing, remove any urethane/primer along the glass perimeter within 11 mm
(0.43 in) of the silver antenna printing.
4. Before reassembly, measure the distance between the urethane/primer and the silver printing on the glass to verify the minimum clearance of
11 mm (0.43 in).
5. Install all trim that was removed in Step 1. Refer to Quarter Upper Trim Panel Replacement and Rear Window Trim Panel Replacement in
SI.
Parts Information
Warranty Information
Important
Only one labor operation may be claimed, depending on the actual repair.
For vehicles repaired under warranty, use:
