2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 677
Conditions for Running the DTC
The memory seat control module must be powered.
Conditions for Setting the DTC
B3606 01
The analog input from the adjustable brake pedal position sensor is greater than 4.75 V, the sensor will be considered out of range and the memory
seat control module will set this DTC.
B3606 06
The analog input from the adjustable brake pedal position sensor is less than 0.22 V, the sensor will be considered out of range and the memory seat
control module will set this DTC.
B3606 5A
This DTC will set if the memory seat control module is controlling the motor in one direction and the adjustable brake pedal position sensor is
tracking the motor in the opposite direction. The sensor is either mounted or wired incorrectly, or the polarity of the motor control circuits are
reversed.
B3606 61
This DTC will set, if the memory seat control module is driving the adjustable pedal motor but does not see a voltage change from the adjustable
brake pedal position sensor.
Action Taken When the DTC Sets
Memory recall functions will be suspended.
Conditions for Clearing the DTC
* The current DTC will become a history DTC when the fault is no longer present and the ignition has been cycled.
* The history DTC will clear after 50 consecutive fault-free ignition cycles have occurred.
Reference Information
Schematic Reference
Adjustable Pedal Schematics (See: Accessories and Optional Equipment/Pedal Positioning System/Diagrams/Electrical Diagrams)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)
Description and Operation
Adjustable Pedals Description and Operation (See: Accessories and Optional Equipment/Pedal Positioning System/Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
Ignition ON, observe the scan tool Adjustable Pedals Position Sensor parameters. The readings should be between 1.5 V and 3.4 V and change
while adjusting the pedals position.
Circuit/System Testing
