2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2505
Component Testing
Steering Wheel Control Switch - Left
1. Disconnect the harness connector at the steering wheel controls switch - left.
2. Cruise control switch ON, measure the resistance between terminal 1 and terminal 3 while individually activating and holding each cruise
control function switch and compare the resistance reading to the values in the table below.
瀚慖f not within the specified resistance range, replace the steering wheel controls switch - left.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Steering Wheel Control Switch Assembly Replacement (See: Accessories and Optional Equipment/Sensors and Switches - Accessories and
Optional Equipment/Steering Mounted Controls Assembly/Service and Repair)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, setup and programming
P0568
DTC P0564, P0567, or P0568
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC P0564
- Cruise Control Multifunction Switch Circuit
DTC P0567
- Cruise Control Resume Switch Circuit
DTC P0568
- Cruise Control Set Switch Circuit
Diagnostic Fault Information
Circuit/System Description
The cruise control switch is an input to the body control module (BCM). The BCM monitors the cruise control on/off, set/coast, resume/accelerate
and cancel switches via the cruise control switch signal circuit in order to detect when the driver has requested to perform a cruise control function.
The BCM detects a specific voltage signal on the cruise control switch signal circuit when a switch is applied. The BCM sends a serial data
message to the ECM indicating the status of the cruise control switches.
