2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2545
* Ignition voltage is 8.6 volts or greater.
Conditions for Setting the DTC
P0601
The read only memory (ROM) test has failed 5 or more times.
P0602
The transmission control module (TCM) has not been programmed.
P0603
The TCM has detected a memory checksum error.
P0604
The TCM random access memory (RAM) test has failed 5 or more times.
P062F
The TCM has detected non-volatile memory is incorrect during power-down.
Action Taken When the DTC Sets
* DTCs P0601, P0602, P0603, P0604, and P062F are Type A DTCs.
* The TCM shifts to a default gear, shuts down, and turns OFF.
Conditions for Clearing the DTC
DTCs P0601, P0602, P0603, P0604, and P062F are Type A DTCs.
Reference Information
Description and Operation
Electronic Component Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and
Operation/6L45/6L50/6L80/6L90 - Automatic Transmission/Electronic Component Description)
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code
(DTC) Type Definitions)
Circuit/System Verification
1. Ignition OFF for one minute.
Caution: Before programming a control module, the following must be observed, or control module damage may occur:
* The scan tool and the terminal must have the latest software.
* The vehicle battery must be fully charged. The battery voltage should be between 12-14 volts.
* The scan tool and the terminal cable connections must be secure.
* A battery charger must NOT be connected to the battery when programming a control module.
2. Ignition ON, with a scan tool verify that DTC P0602 is not set.
瀚慖f DTC P0602 is set, program the transmission control module. Refer to Service Programming System (SPS) (See: Testing and
Inspection/Programming and Relearning/Service Programming System (SPS)) and Control Solenoid Valve and Transmission Control
Module Assembly Programming and Setup (2ML70) (See: Powertrain Management/Transmission Control Systems/Relays and Modules
- Transmission and Drivetrain/Relays and Modules - A/T/Control Module/Testing and Inspection/2ML70 - Automatic Transmission
)Control Solenoid Valve and Transmission Control Module Assembly Programming and Setup (6L45/6L50/6L80/6L90) (See:
Powertrain Management/Transmission Control Systems/Relays and Modules - Transmission and Drivetrain/Relays and Modules -
A/T/Control Module/Testing and Inspection/6L45/6L50/6L80/6L90 - Automatic Transmission).
3. Verify with a scan tool that DTCs P0601, P0603, P0604, or P062F are not set.
瀚慖f DTCs P0601, P0603, P0604, or P062F are set, replace the control solenoid valve and transmission control module assembly.
4. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the
conditions that you observed from the Freeze Frame/Failure Records data.
CADILLAC Diagnostic and Repair Information ,Wiring Diagrams. DTC. TSB. Types: TSB, DTC, Wiring Diagrams, OEM Procedures. Trusted by more than 400,000 technicians. OEM accurate fix for faster repairs. Repair Procedures and Labor Times. Factory Auto Repair info. Request A Demo Today. Factory-Correct Diagrams. Factory Part Numbers. Maintenance Schedules. Repair Procedures. Labor Times. Types: TSB, DTC.