2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2722
4. Connect DT-47825-10 - jumper harness between the vehicle wire harness electrical connector, and the Q8 control solenoid valve assembly
electrical connector.
5. Ignition ON, verify with a scan tool the following test status parameters display OK:
* Line Pressure Control Solenoid Performance Test Status
* Line Pressure Control Solenoid Control Circuit High Voltage Test Status
* Line Pressure Control Solenoid Control Circuit Low Voltage Test
瀚慖f any test status parameter displays Fault or Malfunction, replace the Q8 control solenoid valve assembly.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Control solenoid valve assembly replacement. Refer to Control Module References (See: Testing and Inspection/Programming and
Relearning) for replacement, setup, and programming.
* Perform the Service Fast Learn Adapts (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and
Inspection/Programming and Relearning) following all transmission related repairs.
6L50/6L80/6L90 - Automatic Transmission
DTC P0961-P0963
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC P0961
- Line Pressure Control (PC) Solenoid System Performance
DTC P0962
- Line Pressure Control (PC) Solenoid Control Circuit Low Voltage
DTC P0963
- Line Pressure Control (PC) Solenoid Control Circuit High Voltage
Diagnostic Fault Information
Typical Scan Tool Data
Circuit/System Description
The line pressure control (PC) solenoid is part of the control solenoid valve assembly which has no serviceable parts. The normally high line PC
solenoid regulates and directs the PC solenoid oil pressure to the isolator/pressure regulator valve. Increasing PC solenoid line pressure increases
transmission line pressure. The TCM varies the current to the line PC solenoid through a low side driver. Decreasing the current to the line PC
