2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2557
is in the start position. The BCM sends a serial data message to the engine control module (ECM) that crank has been requested. The ECM then
verifies that the automatic transmission is in Park or Neutral, and that the immobilizer is not disabling engine starting. If conditions are acceptable
for cranking, then the ECM supplies 12 V to the control circuit of the STRTR relay. When this occurs, battery voltage is supplied through the
switch of the STRTR relay to terminal S X2 of the starter solenoid, and the engine cranks. The ECM monitors the voltage on the STRTR relay
control circuit. If the ECM detects that the STRTR relay control circuit is open, shorted to ground, or shorted to voltage, then DTC P0615 sets.
Conditions for Running the DTC
* The ignition is ON or in the start position.
* The battery voltage is 9.5-18 V.
Conditions for Setting the DTC
The ECM detects that the control circuit of the STRTR relay is open, shorted to ground, or shorted to voltage for 2 seconds.
Action Taken When the DTC Sets
DTC P0615 is a type C DTC.
Conditions for Clearing the DTC
The DTC passes when the ECM detects that the failure is no longer present for 2 seconds.
Reference Information
Schematic Reference
Starting and Charging Schematics (See: Starting and Charging/Diagrams/Electrical Diagrams)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Starting System Description and Operation (See: Starting and Charging/Starting System/Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code
(DTC) Type Definitions)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
1. Ignition ON. Verify that no immobilizer or automatic transmission DTCs are set that would cause the ECM to disable engine starting.
瀚慖f any DTCs are set that would cause the ECM to disable starting, then refer to Diagnostic Trouble Code (DTC) List - Vehicle (See:
Diagnostic Trouble Code Descriptions/Diagnostic Trouble Code (DTC) List - Vehicle).
2. Attempt to start the engine. The engine should crank.
Circuit/System Testing
1. Ignition OFF, disconnect the STRTR relay.
2. Ignition OFF and scan tool disconnected, open and close the driver door, and wait 1 minute. Test for less than 5 Ohms between the relay
ground circuit terminal 85 and ground.
瀚慖f greater than the specified range, test the ground circuit for an open/high resistance.
3. Connect a test lamp between the control circuit terminal 86 and the ground circuit terminal 85. Turn the ignition to the start position. The test
