2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2511
ECM.
5. If all circuits test normal, test or replace the stop lamp switch.
Component Testing
1. Ignition OFF, disconnect the harness connector at the stop lamp switch.
2. With the brake pedal released, test for infinite resistance between terminal A and terminal B at the stop lamp switch.
瀚慖f not the specified value, replace the stop lamp switch.
3. With the brake pedal released, test for less than 1.0 ohm between terminal C and terminal D at the stop lamp switch.
瀚慖f not the specified value, replace the stop lamp switch.
4. With the brake pedal applied, test for less than 1.0 ohm between terminal A and terminal B at the stop lamp switch.
瀚慖f not the specified value, replace the stop lamp switch.
5. With the brake pedal applied, test for infinite resistance between terminal C and terminal D at the stop lamp switch.
瀚慖f not the specified value, replace the stop lamp switch.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Stop Lamp Switch Replacement (With Adjustable Pedals) (See: Lighting and Horns/Brake Light Switch/Service and Repair/Stop Lamp
Switch Replacement (With Adjustable Pedals))Stop Lamp Switch Replacement (Without Adjustable Pedals) (See: Lighting and
Horns/Brake Light Switch/Service and Repair/Stop Lamp Switch Replacement (Without Adjustable Pedals))
* Control Module References (See: Testing and Inspection/Programming and Relearning) for ECM replacement, setup, and programming
P0575
DTC P0575
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC P0575
- Cruise Control Switch Signal Circuit
Circuit/System Description
When a cruise control function switch is activated, the body control module (BCM) detects a predetermined voltage signal. The BCM sends a serial
data message to the engine control module (ECM) indicating the function that has been requested.
Conditions for Running the DTC
* The ignition is ON.
* The cruise switch is ON.
Conditions for Setting the DTC
* The ECM receives an invalid cruise control switch status serial data message from the BCM.
* This diagnostic runs continuously.
Actions Taken When the DTC Sets
* The cruise control system becomes disabled.
* The malfunction indicator lamp (MIL) will not illuminate.
