2010 Cadillac CTS Sedan AWD V6-3.6L Page 1674
DTC P0796
- Clutch Pressure Control (PC) Solenoid 3 - Stuck Off
DTC P0797
- Clutch Pressure Control (PC) Solenoid 3 - Stuck On
Circuit/System Description
The clutch pressure control (PC) solenoid 3 is part of the control solenoid valve assembly, which has no serviceable parts. The PC solenoid 3
regulates transmission fluid pressure to the CBR1/C 4-5-6 clutch regulator valve which controls pressure to the 4-5-6 clutch. The TCM calculates
gear ratio based on the RPM signals from the input speed sensor (ISS) and the output speed sensor (OSS). The TCM compares the expected
transmission gear ratio to the calculated gear ratio for each commanded gear.
Conditions for Running the DTC
P0796
* DTCs P0716, P0717, P0722, P0723, P182E or P1915 are not set.
* High side driver (HSD) is enabled.
* The throttle position is 10 percent or greater.
* The transmission input shaft speed is 60 RPM or greater.
* Low and reverse/4-5-6 clutch is commanded ON.
P0797
* DTCs P0716, P0717, P0722, P0723, P182E or P1915 are not set.
* High side driver (HSD) is enabled.
* The throttle position is 10 percent or greater.
* The transmission output shaft speed is 200 RPM or greater.
* Low and reverse/4-5-6 clutch is commanded OFF.
Conditions for Setting the DTC
P0796
The TCM detects an incorrect on-coming clutch gear ratio, or flare, when the low and reverse/4-5-6 clutch is commanded ON for 2 seconds and the
transmission input shaft speed is 75 RPM or greater from the anticipated input shaft speed.
P0797
The TCM detects an incorrect off-going clutch gear ratio, or tie-up, when the low and reverse/4-5-6 clutch is commanded OFF for 2 seconds and
the transmission input shaft speed is 40 RPM or less from the anticipated input shaft speed.
Action Taken When the DTC Sets
* DTCs P0796 and P0797 are Type A DTCs.
* The TCM commands maximum line pressure.
* The TCM inhibits TCC.
* The TCM freezes transmission adaptive functions.
* The TCM enables torque management.
Conditions for Clearing the DIC/DTC
DTCs P0796 and P0797 are Type A DTCs.
Diagnostic Aids
Before performing a road test, configure and setup the scan tool for snapshot mode. This will allow you to display, monitor, and verify multiple
transmission data parameters at one time, after the road test.
Reference Information
Connector End View Reference
* Component Connector End Views (See: Diagrams/Connector Views)
* Inline Harness Connector End Views (See: Power and Ground Distribution/Multiple Junction Connector/Diagrams)
Description and Operation
* Electronic Component Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and
Operation/Electronic Component Description)
* Transmission General Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and
