Wednesday, February 19, 2020

2010 Cadillac CTS Sedan AWD V6-3.6L Page 1545

2010 Cadillac CTS Sedan AWD V6-3.6L Page 1545



Verify the injector test lamp illuminates brightly and then turns OFF.



瀚慖f the injector test lamp does not illuminate, replace the engine control module.



7. If all circuits test normal, replace the throttle body.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Throttle Body Assembly Replacement (LF1) (See: Powertrain Management/Fuel Delivery and Air Induction/Throttle Body/Service and



Repair/Removal and Replacement)Throttle Body Assembly Replacement (LLT) (See: Powertrain Management/Fuel Delivery and Air



Induction/Throttle Body/Service and Repair/Removal and Replacement)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for engine control module replacement, setup, and



programming



P0641 or P06A6



DTC P0641 or P06A6



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions)provides an overview of each diagnostic category.



DTC Descriptors



DTC P0641



- 5 V Reference Circuit



DTC P06A6



- 5 V Reference Performance



Diagnostic Fault Information



Circuit/System Description



The fuel pressure sensor is located on the fuel line. The fuel pressure sensor monitors the fuel pressure in the fuel line. The fuel pump control



module monitors the voltage signal from the fuel pressure sensor.



Conditions for Running the DTC



The ignition is ON.



Conditions for Setting the DTC



The fuel pump control module detects that the fuel pressure 5 V reference is above or below a predetermined voltage threshold.



Action Taken When the DTC Sets



DTCs P0641 and P06A6 are Type A DTCs.



Conditions for Clearing the DTC



DTCs P0641 and P06A6 are Type A DTCs.



Diagnostic Aids



Using the Failure Records data may help locate an intermittent condition. If you cannot duplicate the DTC, the information in the Failure Records