2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1362
Repairs/Wiring Repairs)
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code
(DTC) Type Definitions)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning)for scan tool information
Special Tools
* J 41413-SPT High Intensity White Light
* J 41413-VLV EVAP Port Vent Fitting Tool
* J 41413-200 Evaporative Emissions System Tester (EEST)
* J 41413-300 EVAP Cap and Plug Kit
* CH-48096 EVAP Service Port Access Tool
* GE-41415-50 Fuel Tank Cap Adapter
Circuit/System Testing
1. Ignition OFF, remove the fuel fill cap. Connect the GE-41415-50 to the fuel tank filler neck. Connect the J 41413-200 to the GE-41415-50
.
2. Ignition ON, seal the system using the Purge Seal function with a scan tool.
3. Pressurize the EVAP system with nitrogen to 9.33 mm/Hg (5 in. H2O). Compare the scan tool Fuel Tank Pressure Sensor parameter to the J
41413-200 pressure/vacuum gauge. Verify the fuel tank pressure sensor parameter is within +/-0.9 mmHg (+/-0.5 in.H2O) of the
pressure/vacuum gauge.
瀚慖f not within the specified range, replace the B150 fuel tank pressure sensor.
4. Command the EVAP vent solenoid valve OPEN with a scan tool. Verify the scan tool Fuel Tank Pressure Sensor parameter is -0.9 to +0.9
mmHg (-0.5 to +0.5 in.H2O).
瀚慖f not within the specified range, replace the B150 fuel tank pressure sensor.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Fuel Tank Pressure Sensor Replacement (See: Powertrain Management/Computers and Control Systems/Fuel Tank Pressure Sensor/Service and
Repair)
P0452
DTC P0452 or P0453 (LAU)
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC P0452
- Fuel Tank Pressure Sensor Circuit Low Voltage
DTC P0453
- Fuel Tank Pressure Sensor Circuit High Voltage
Diagnostic Fault Information
