2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1568
P0713
* No DTCs P0713, P0716, P0717, P0722, or P0723.
* The engine speed is greater than 400 RPM for 5 seconds.
* The ignition voltage is 8.6 volts or greater.
Conditions for Setting the DTC
P0711
The difference between the transmission fluid temperature (TFT) and TCM temperature and the difference between the TFT and TCM power up
temperature are both greater than 20-50掳C (36-90掳F). The temperature threshold is dependent on the average temperature of the TFT, TCM
temperature, and TCM power up temperature.
P0712
The TFT is less than -74掳C (-101掳F) for 1 minute.
P0713
The TFT is 174掳C (345掳F) or greater for 1 minute.
Action Taken When the DTC Sets
* DTCs P0711, P0712, and P0713 are Type B DTCs.
* The TCM defaults the TFT to the TCM Temperature.
Conditions for Clearing the DTC
DTCs P0711, P0712, and P0713 are Type B DTCs.
Diagnostic Aids
The transmission control module (TCM) temperature sensor is located inside of the control solenoid valve assembly and its output should resemble
that of the transmission fluid temperature (TFT) sensor's output.
Reference Information
Connector End View Reference
* Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)
* Inline Harness Connector End Views (See: Diagrams/Connector Views/Multiple Junction Connector/Connector End Views By Number)
Description and Operation
Electronic Component Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and Operation/6T70/6T75 -
Automatic Transmission/Electronic Component Description) for control solenoid valve assembly
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code
(DTC) Type Definitions)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
1. Engine idling at operating temperature, verify the scan tool Trans Fluid Temp. parameter is between -74 and +174掳C (-101 and +345掳F).
瀚慖f not within the specified range, replace the control solenoid valve assembly.
