2010 Cadillac CTS Sedan AWD V6-3.6L Page 1661
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Replace the control solenoid valve assembly. Refer to Control Module References (See: Testing and Inspection/Programming and
Relearning) for replacement, setup, or programming.
* Perform the Service Fast Learn Adapts (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and
Inspection/Programming and Relearning/Service Fast Learn Adapts) following all transmission related repairs.
P0752
DTC P0751 or P0752
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC P0751
- Shift Solenoid (SS) 1 Valve Performance - Stuck OFF
DTC P0752
- Shift Solenoid (SS) 1 Valve Performance - Stuck ON
Circuit/System Description
The shift solenoid (SS) 1 is part of the control solenoid valve assembly which has no serviceable parts. The control solenoid valve assembly is
attached to the lower control valve body. The solenoid operates by the TCM opening or closing the ground circuit. With the solenoid circuit
grounded (solenoid on), the internal plunger and metering ball block the exhaust fluid creating signal fluid pressure. The signal fluid acts against
the clutch select valve 2 to overcome the valve spring force moving it to the apply position, allowing the shift. The TCM shifts the transmission by
operating the solenoids in on/off combinations.
Conditions for Running the DTC
P0751 or P0752
* DTCs P0121, P0122, P0123, P0716, P0717, P0722, P0723, and P0182E are not set.
* Ignition voltage is 8.6 V or greater.
* The engine speed is 500 RPM or greater for 5 seconds.
* The IMS range is not PARK, NEUTRAL or REVERSE.
* High Side Driver (HSD) is enabled.
* The transmission fluid temperature is 0-130掳C (32-266掳F).
* Accelerator pedal position signal is valid.
* The throttle position signal is valid.
* The output shaft speed is 0 RPM or greater.
* The TCM must receive a valid torque signal from the ECM.
Conditions for Setting the DTC
