2010 Cadillac CTS Sedan AWD V6-3.6L Page 1502
If the DTC is set, program the K27 fuel pump control module.
Verify that DTCs P0601, P0603, P0604, P0606, and P062F are not set.
If the DTCs are set, program the K27 fuel pump control module. If the DTCs reset, replace the K27 fuel pump control module.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Control Module References (See: Testing and Inspection/Programming and Relearning) for fuel pump control module replacement, setup, and
programming
P0601-P0604 or P062F
DTC P0601-P0604 or P062F
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
Note: DTCs P0601, P0602, P0603, P0604 or P062F could set in other control modules. Verify the DTCs are set in the transmission control module
(TCM).
DTC P0601
- Control Module Read Only Memory (ROM)
DTC P0602
- Control Module Not Programmed
DTC P0603
- Control Module Long Term Memory Reset
DTC P0604
- Control Module Random Access Memory (RAM)
DTC P062F
- Control Module Long Term Memory Performance
Circuit/System Description
This is an internal fault detection of the control solenoid valve assembly. This fault is carried out inside the control solenoid valve assembly and no
external circuits are involved.
Conditions for Running the DTC
* DTCs P0601, P0602, P0603, P0604, or P062F are not set.
* Ignition voltage is 8.6 volts or greater.
Conditions for Setting the DTC
P0601
The read only memory (ROM) test has failed 5 or more times.
P0602
The transmission control module (TCM) has not been programmed.
