2010 Cadillac CTS Sedan AWD V6-3.6L Page 2023
The clutch pressure control (PC) solenoid 5 is part of the control solenoid valve assembly, which has no serviceable parts. The PC solenoid 5
regulates transmission fluid pressure to the 1-2-3-4 clutch regulator valve which controls pressure to the 1-2-3-4 clutch. The TCM calculates gear
ratio based on the RPM signals from the input speed sensor (ISS) and the output speed sensor (OSS). The TCM compares the expected
transmission gear ratio to the calculated gear ratio for each commanded gear.
Conditions for Running the DTC
P2723
* DTCs P0716, P0717, P0722, P0723, P1825, or P1915 are not set.
* The transmission input shaft speed is greater than 60 RPM.
* 1-2-3-4 clutch is commanded ON.
P2724
* DTCs P0716, P0717, P0722, P0723, P1825, or P1915 are not set.
* The transmission input speed is equal to or greater than 200 RPM.
* The transmission output shaft speed is equal to or greater than 200 RPM.
* 1-2-3-4 clutch is commanded OFF.
Conditions for Setting the DTC
P2723
The TCM detects an incorrect on-coming clutch gear ratio, or flare, when the 1-2-3-4 clutch is commanded ON for 0.5 seconds and either fail case
below is achieved:
Condition 1
* Output shaft speed is greater than 60 RPM.
* The transmission input shaft speed is greater than 75 RPM from the anticipated input shaft speed.
Condition 2
* Output shaft speed is less than 60 RPM.
* The transmission input shaft speed is greater than 75 RPM from the anticipated input shaft speed.
P2724
The TCM detects an incorrect off-going clutch gear ratio, or tie-up, when the 1-2-3-4 clutch is commanded OFF for 0.5 seconds and the following
is achieved:
* The 1-2-3-4 clutch commanded pressure is 0 kPa for a calculated amount of time.
* The transmission input shaft speed is less than 40 RPM from the anticipated input shaft speed.
* The output shaft speed is greater than 60 RPM.
Action Taken When the DTC Sets
* DTCs P2723 and P2724 are Type A DTCs.
* The TCM freezes transmission adaptive functions.
* DTC P2723 defaults to Reverse, Park, Neutral, 5th, or 6th gear.
* DTC P2724 defaults to Reverse, Park, Neutral, 1st, or 2nd gear.
Conditions for Clearing the DIC/DTC
DTCs P2723 and P2724 are Type A DTCs.
Diagnostic Aids
Before performing a road test, configure and setup the scan tool for snapshot mode. This will allow you to display, monitor, and verify multiple
transmission data parameters at one time, after the road test.
Reference Information
Connector End View Reference
* Component Connector End Views (See: Diagrams/Connector Views)
* Inline Harness Connector End Views (See: Power and Ground Distribution/Multiple Junction Connector/Diagrams)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit
