2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 714
This DTC can set only when the output is actively being requested by the BCM.
Conditions for Setting the DTC
If the BCM detects a short to ground in the WIPER 1 relay control circuit.
Action Taken When the DTC Sets
The BCM will not activate the output.
Conditions for Clearing the DTC
* The current DTC will become history when the request for the output is removed or when the condition for setting the fault is corrected.
* The history DTC will clear after 50 consecutive ignition cycles without a fault present.
Reference Information
Schematic Reference
Wiper/Washer Schematics (See: Wiper and Washer Systems/Diagrams/Electrical Diagrams)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Wiper/Washer System Description and Operation (See: Wiper and Washer Systems/Description and Operation/Wiper/Washer System Description
and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
Ignition ON, wiper switch in LOW position. Verify the windshield wipers are cycling at the low speed.
Circuit/System Testing
1. Ignition OFF, disconnect the X5 harness connector at the BCM.
2. Ignition ON, verify that the low speed wipers are not on.
瀚慖f the low speed wipers are on, test the WIPER 1 relay control circuit terminal 20 for a short to voltage. If the circuit tests normal, replace
the underhood fuse block.
3. Install a 10A fused jumper wire between the WIPER 1 relay control circuit terminal 20 and B+. Verify the low speed wipers are on.
瀚慖f the low speed wipers are not on, test the relay control circuit for an open/high resistance or short to ground. If the circuit tests normal
replace the underhood fuse block.
4. If all circuits test normal, replace the BCM.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Underhood Electrical Center or Junction Block Replacement (See: Maintenance/Fuses and Circuit Breakers/Fuse Block/Service and
Repair/Removal and Replacement/Underhood Electrical Center or Junction Block Replacement)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, setup, and programming
