Friday, December 27, 2019

2010 Cadillac Truck Escalade AWD V8-6.2L Page 2970

Conditions for Clearing the DTC

* A current DTC clears when the malfunction is no longer present.

* A history DTC clears when the module ignition cycle counter reaches the reset threshold of 50, without a repeat of the malfunction.

Diagnostic Aids

* DTC U1815 can set current in the HPCM, ECM, and the SDGM.

* If DTC U1815 is only set in the HPCM, the PIM must be replaced due to all circuits between the HPCM and MCM being internal to the PIM.

Reference Information

Schematic Reference

* Data Communication Schematics (See: Powertrain Management/Computers and Control Systems/Information Bus/Diagrams/Electrical

Diagrams)

* Control Module References (See: Testing and Inspection/Programming and Relearning)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Data Link Communications Description and Operation (See: Powertrain Management/Computers and Control Systems/Information

Bus/Description and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Circuit/System Verification

1. Verify that DTC B137A is not current in the serial data gateway module (SDGM).

锟斤拷If the DTC is current in the SDGM, refer to Diagnostic Trouble Code (DTC) List - Vehicle (See: Diagnostic Trouble Code

Descriptions/Diagnostic Trouble Code (DTC) List - Vehicle).

2. Verify that DTC U1815 is not set current only in the HPCM.

锟斤拷If the DTC is current in the HPCM only, replace the drive motor power inverter module (PIM).

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector X1 at the PIM.

2. Test for less than 5 ohms between the PIM case and ground.

锟斤拷If greater than the specified range, test the ground strap for an open/high resistance. If the circuit tests normal, replace the PIM.

3. Ignition ON, verify that a test lamp illuminates between the following voltage circuit terminals of the PIM and ground.

* Terminal 6

* Terminal 7

* Terminal 20

锟斤拷If the test lamp does not illuminate, test the circuit for a short to ground or an open/high resistance.

4. Ignition ON, verify that a test lamp illuminates between the signal circuit terminal 19 and ground.

锟斤拷If the test lamp does not illuminate, test the circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the

SDGM.

5. Ignition OFF, disconnect the harness connector X3 at the engine control module.

6. Test for less than 1.0 ohm on the high speed hybrid GMLAN serial data circuits between the following ECM and PIM circuit terminals.