valve assembly function.
5. Inspect the control valve upper body assembly for sticking valves, damage, scored bores, or debris.
锟斤拷If a concern is found in the valve body, repair or replace the valve body as necessary.
Component Testing
* Perform the Control Solenoid Valve and Transmission Control Module Assembly Inspection (See: Transmission and Drivetrain/Automatic
Transmission/Transaxle/Testing and Inspection/Component Tests and General Diagnostics/2ML70 - Automatic Transmission/Control
Solenoid Valve and Transmission Control Module Assembly Inspection).
* Perform the Control Solenoid Valve and Transmission Control Module Assembly Solenoid Performance Test (See: Transmission and
Drivetrain/Automatic Transmission/Transaxle/Testing and Inspection/Component Tests and General Diagnostics/2ML70 - Automatic
Transmission/Control Solenoid Valve and Transmission Control Module Assembly Solenoid Performance Test).
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Control Solenoid Valve and Transmission Control Module Assembly Replacement (See: Transmission and Drivetrain/Automatic
Transmission/Transaxle/Extension Housing/Service and Repair/Control Solenoid Valve and Transmission Control Module Assembly
Replacement) for control valve body repair or replacement.
* Control Module References (See: Testing and Inspection/Programming and Relearning) for Q8 control solenoid valve assembly
replacement, setup, and programming.
6L50/6L80/6L90 - Automatic Transmission
DTC P2714 or P2715
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC P2714
- Clutch Pressure Control (PC) Solenoid 4 - Stuck Off
DTC P2715
- Clutch Pressure Control (PC) Solenoid 4 - Stuck On
Circuit/System Description
The clutch pressure control (PC) solenoid 4 is part of the control solenoid valve assembly, which has no serviceable parts. The PC solenoid 4
regulates transmission fluid pressure to the 2-6 clutch regulator valve which controls pressure to the 2-6 clutch. The TCM calculates gear ratio
based on the RPM signals from the input speed sensor (ISS) and the output speed sensor (OSS). The TCM compares the expected transmission gear
ratio to the calculated gear ratio for each commanded gear.
Conditions for Running the DTC
P2714
* DTCs P0716, P0717, P0722, P0723, P1825, or P1915 are not set.
* The transmission input shaft speed is greater than 60 RPM.
* 2-6 clutch is commanded ON.
P2715
* DTCs P0716, P0717, P0722, P0723, P1825, or P1915 are not set.
* The transmission output shaft speed is greater than 200 RPM.
* 2-6 clutch is commanded OFF.
Conditions for Setting the DTC
P2714
The TCM detects an incorrect on-coming clutch gear ratio, or flare, when the 2-6 clutch is commanded ON for 0.5 seconds and the transmission
