Tuesday, November 26, 2019

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 542

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 542



Circuit/System Description



The driver and front passenger heated seats are controlled by the seat heating control module that is located under the driver seat cushion. When the



heated seat is active, the module applies power through a common voltage supply circuit to the seat heater elements. The module controls the seat



temperature by providing a pulse width modulation (PWM) ground through the seat heater element control circuit to the heater elements. The



module then monitors the current flow through the heating elements and the rate of change of the temperature sensor to verify correct heated seat



operation.



Conditions for Running the DTC



* DTC B1325 must not be present.



* The engine must be running.



* The seat heating control module must be powered and the heated seat must be enabled.



Conditions for Setting the DTC



B2425 0D or B2430 0D



By measuring current and voltage output to the seat heating elements every 10 seconds, the seat heating control module calculates that the heating



element resistance is above the maximum resistance.



B2425 0B, B2425 0E, B2430 0B, or B2430 0E



By measuring current and voltage output to the seat heating elements every 10 seconds, the seat heating control module calculates that the heating



element resistance is below the minimum resistance.



Action Taken When the DTC Sets



The heated seat function for the affected seat will be disabled.



Conditions for Clearing the DTC



* The current DTC clears when the malfunction is no longer present, and the power mode changes to OFF then back to ACC or RUN.



* The history DTC will clear after 40 consecutive fault-free ignition cycles have occurred.



Reference Information



Schematic Reference



Heated/Cooled Seat Schematics (See: Body and Frame/Seats/Seat Temperature Element/Diagrams/Electrical Diagrams)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Heated/Vented Seat Description and Operation (See: Body and Frame/Seats/Seat Temperature Element/Description and Operation/Heated/Vented



Seat)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)