2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 462
DTC B1516 66
- Battery Current Sensor Performance Wrong Mounting Position - 12V
Diagnostic Fault Information
Typical Scan Tool Data
Circuit/System Description
The battery current sensor is a 3 wire hall effect current sensor. The battery current sensor monitors the battery current. The signal circuit is an input
to the body control module (BCM). The sensor creates a 5 volt pulse width modulation (PWM) signal of 128 Hz with a duty cycle of 0-100 percent.
Normal duty cycle is between 4-96 percent. The signal circuit is an input to the body control module (BCM). If the duty cycle is outside of the
normal range, DTC B1516 08 sets. The BCM also tests for correct polarity of the sensor. If the BCM detects positive current flow with the engine
OFF, DTC B1516 66 sets.
Conditions for Running the DTC
B1516 08
The BCM is awake.
B1516 66
* The BCM is awake.
* The engine is OFF.
* The hood and doors are closed.
* DTC B1516 08 has run and passed during this ignition cycle.
* DTC B1516 66 has not already run and passed during this ignition cycle.
Conditions for Setting the DTC
B1516 08
The BCM detects the PWM duty cycle on the sensor signal circuit is less than 4 percent or greater than 96 percent for 2 minutes.
B1516 66
The BCM detects positive battery current when the engine is OFF.
Action Taken When the DTC Sets
Regulated voltage control (RVC) is disabled.
Conditions for Clearing the DTC
* The DTC passes when the 12V battery sensed current returns to normal range for 15 seconds.
