Friday, November 15, 2019

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 717

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 717

Action Taken When the DTC Sets

The keyless entry system is inoperative.

Conditions for Clearing the DTC

The DTC is cleared when a normal transmitter voltage signal is received from the programmed transmitter that set the DTC.

Diagnostic Aids

The keyless entry transmitter used in the 2-Way Advanced Remote Start System is unique to the system. When servicing or replacing a transmitter,

ensure that the correct transmitter is used. The correct transmitter part number can be found in the Accessory section of the parts catalog.

Attempting to replace a 2-Way Advanced Remote Start transmitter with a regular service part may result in a failure to program the transmitter.

Reference Information

Schematic Reference

Remote Function Schematics (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Keyless Entry/Keyless Entry

Transmitter/Diagrams/Electrical Diagrams)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Keyless Entry System Description and Operation (Without Accessory 2 Way Remote) (See: Accessories and Optional Equipment/Antitheft and

Alarm Systems/Keyless Entry/Description and Operation/Keyless Entry System Description and Operation (Without Accessory 2 Way Remote)

)Keyless Entry System Description and Operation (With Accessory 2 Way Remote) (See: Accessories and Optional Equipment/Antitheft and

Alarm Systems/Keyless Entry/Description and Operation/Keyless Entry System Description and Operation (With Accessory 2 Way Remote))

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Verify DTC B3109, B3110, B3111, or B3112 are not set.

If any of the DTCs are set, replace the battery in the appropriate keyless entry transmitter. Operate the transmitter 3 consecutive times. If the DTC

resets, replace the keyless entry transmitter.

Repair Instructions

Important: This vehicle may be equipped with the 2-Way Advanced Remote Start System. Vehicle equipped with the 2-Way Advanced

Remote Start System can be identified by an LCD screen on the keyless entry transmitter or a yellow label on the RCDLR. When servicing

the 2-Way Advanced Remote Start System, ensure that the correct parts are installed during replacement. Service parts for the 2-Way

Advanced Remote Start System can be found in the Accessory section of the parts manual.

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

Remote Control Door Lock Transmitter Programming (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Keyless

Entry/Keyless Entry Transmitter/Testing and Inspection)

B3111

DTC B3109, B3110, B3111, or B3112

Diagnostic Instructions