Friday, November 15, 2019

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 716

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 716

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Verify DTC B3109, B3110, B3111, or B3112 are not set.

If any of the DTCs are set, replace the battery in the appropriate keyless entry transmitter. Operate the transmitter 3 consecutive times. If the DTC

resets, replace the keyless entry transmitter.

Repair Instructions

Important: This vehicle may be equipped with the 2-Way Advanced Remote Start System. Vehicle equipped with the 2-Way Advanced

Remote Start System can be identified by an LCD screen on the keyless entry transmitter or a yellow label on the RCDLR. When servicing

the 2-Way Advanced Remote Start System, ensure that the correct parts are installed during replacement. Service parts for the 2-Way

Advanced Remote Start System can be found in the Accessory section of the parts manual.

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

Remote Control Door Lock Transmitter Programming (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Keyless

Entry/Keyless Entry Transmitter/Testing and Inspection)

B3110

DTC B3109, B3110, B3111, or B3112

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC B3109 00

- Keyless Entry Transmitter 1 Low Battery

DTC B3110 00

- Keyless Entry Transmitter 2 Low Battery

DTC B3111 00

- Keyless Entry Transmitter 3 Low Battery

DTC B3112 00

- Keyless Entry Transmitter 4 Low Battery

Circuit/System Description

With each press of a keyless entry transmitter button, a message containing the current battery state of the transmitter is sent to the remote control

door lock receiver (RCDLR) along with the commanded keyless entry function.

Conditions for Running the DTC

A keyless transmitter button is pressed.

Conditions for Setting the DTC

The DTC sets after 3 consecutive low battery signals from the same programmed transmitter.