2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 1048
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions)provides an overview of each diagnostic category.
DTC Descriptor
DTC C1100 00
- Base Brake System Pressure Circuit
Diagnostic Fault Information
Circuit/System Description
The electronic brake control module (EBCM) provides a 5 V reference circuit to the brake booster vacuum sensor and the steering angle sensor.
The brake booster vacuum sensor converts the change in vacuum levels in the brake booster into a signal voltage ranging from 0.13 - 3.30 V and is
monitored by EBCM.
Conditions for Running the DTC
Ignition ON.
Conditions for Setting the DTC
The brake booster sensor signal voltage is not within 0.13 - 3.30 V for more than 1 second.
Conditions for Clearing the DTC
* The condition for the DTC is no longer present.
* The EBCM clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.
Reference Information
Schematic Reference
Hydraulic Brake Schematics (See: Brakes and Traction Control/Hydraulic System/Diagrams/Electrical Diagrams)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Brake Assist System Description and Operation (Vacuum Assist) (See: Brakes and Traction Control/Hydraulic System/Description and
Operation/Brake Assist System Description and Operation (Vacuum Assist))Brake Assist System Description and Operation (Hydraulic Assist) (
See: Brakes and Traction Control/Hydraulic System/Description and Operation/Brake Assist System Description and Operation (Hydraulic Assist))
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning)for scan tool information
Circuit/System Testing
Note: If only DTC C1100 is set refer to Only DTC C1100 Set, if both DTC C0710 and C1100 are set, refer to Both DTC C0710 and C1100 Set.
