Saturday, November 16, 2019

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 724

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 724

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Command the Lock Rear Doors and Unlock Rear Doors with a scan tool, the rear doors should perform the LOCK and UNLOCK function.

Circuit/System Testing

1. Ignition OFF, disconnect the X3 harness connector at the I/P fuse block.

2. Connect a test lamp between the control circuit terminal A2 and ground.

3. Ignition ON, command the Lock Rear Doors with a scan tool. The test lamp should briefly illuminate during the LOCK command.

瀚慖f the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace

the BCM.

瀚慖f the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the BCM.

4. Connect a test lamp between the control circuit terminal A3 and B+.

5. Command the Unlock Rear Doors with a scan tool. The test lamp should briefly illuminate during the UNLOCK command.

瀚慖f the test lamp is always OFF, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace

the BCM.

瀚慖f the test lamp is always ON, test the control circuit for a short to ground. If the circuit tests normal, replace the BCM.

6. If all circuits test normal, replace the I/P fuse block.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Instrument Panel Electrical Center or Junction Block Replacement - Left Side (See: Maintenance/Fuses and Circuit Breakers/Fuse

Block/Service and Repair/Removal and Replacement/Instrument Panel Electrical Center or Junction Block Replacement - Left Side)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, setup and programming

B3205

DTC B3205

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC B3205 00

- Window Inactive Over Current Fault

DTC B3205 0B

- Window Motor Fast Over Current Fault

Diagnostic Fault Information