Diagnostic and Repair Information ,Wiring Diagrams. DTC. TSB. Types: TSB, DTC, Wiring Diagrams, OEM Procedures. Trusted by more than 400,000 technicians. OEM accurate fix for faster repairs. Repair Procedures and Labor Times. Factory Auto Repair info. Request A Demo Today. Factory-Correct Diagrams. Factory Part Numbers. Maintenance Schedules. Repair Procedures. Labor Times. Types: TSB, DTC.car insurance, auto insurance, auto, car, vehicle, insurance, quote, quotes, online, insurance，auto, autos, car, cars, vehicle, vehicles, used car, pre-owned car, pre-owned vehicle, used auto, used vehicle, rental，auto racing news, car racing news
SIR SCHEMATIC ICONS
SIR Schematic Icons
Icon
Icon Definition
CAUTION: When performing service on or near the SIR components or the SIR wiring, the SIR system must be disabled. Refer to SIR Disabling and Enabling. Failure to observe the correct procedure could cause deployment of the SIR components, personal injury, or unnecessary SIR system repairs.
IMPORTANT:
l In order to prevent accidental deployment, the shorting bars close in order to short the connectors when the connectors are separated.
l Twisted-pair wires provide an effective shield that helps protect sensitive electronic components from electrical interference. If the wires were covered with shielding, install new shielding.
In order to prevent electrical interference from degrading the performance of the connected components, you must maintain the proper specification when making any repairs to the twisted-pair wires shown :
. The wires must be twisted a minimum of 9 turns per 31 cm (12 in) as measured anywhere along the length of the wires
. The outside diameter of the twisted wires must not exceed
6.0 mm (0.25 in)
SIR WIRING SCHEMATICS
SIR SCHEMATIC ICONS
SIR Schematic Icons
Icon
Icon Definition
CAUTION: When performing service on or near the SIR components or the SIR wiring, the SIR system must be disabled. Refer to SIR Disabling and Enabling. Failure to observe the correct procedure could cause deployment of the SIR components, personal injury, or unnecessary SIR system repairs.
IMPORTANT:
l In order to prevent accidental deployment, the shorting bars close in order to short the connectors when the connectors are separated.
l Twisted-pair wires provide an effective shield that helps protect sensitive electronic components from electrical interference. If the wires were covered with shielding, install new shielding.
In order to prevent electrical interference from degrading the performance of the connected components, you must maintain the proper specification when making any repairs to the twisted-pair wires shown :
. The wires must be twisted a minimum of 9 turns per 31 cm (12 in) as measured anywhere along the length of the wires
. The outside diameter of the twisted wires must not exceed
6.0 mm (0.25 in)
SIR WIRING SCHEMATICS
