2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 964
DTC C0201 0E
- Antilock Brake System (ABS) Enable Relay Contact Circuit Resistance Below Threshold
DTC C120E
- Traction Control Power Switch Circuit Shorted
Circuit/System Description
The solenoid relay, located within the electronic brake control module (EBCM), supplies battery voltage to all of the valve solenoids.
Conditions for Running the DTC
C0201 04 or C120D
* Ignition voltage is greater than 10 V.
* The solenoid relay is commanded ON.
C0201 0E or C120E
* Ignition voltage is greater than 10 V.
* The solenoid relay is commanded OFF.
Conditions for Setting the DTC
C0201 04 or C120D
* The EBCM detects an open in the circuits to the solenoid valve relay.
* The EBCM detects a stuck open solenoid valve relay.
C0201 0E or C120D
* The EBCM detects an short to battery in the circuits to the solenoid valve relay.
* The EBCM detects a stuck closed solenoid valve relay.
Action Taken When the DTC Sets
* The EBCM disables the antilock brake system (ABS) and the vehicle stability enhancement system for the duration of the ignition cycle.
* A driver information center message and/or a warning indicator may be displayed.
Conditions for Clearing the DTC
* The condition for setting the DTC is no longer present.
* The EBCM clears the history DTC when a current DTC is not detected in 40 consecutive drive cycles.
Reference Information
Schematic Reference
Antilock Brake System Schematics (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Diagrams/Electrical Diagrams)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
ABS Description and Operation (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Description and Operation/ABS
Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the EBCM.
