7. Ignition OFF, remove the jumper wires from the previous step.
8. Measure for 2-3 volts between each of the following circuits and ground on the ECM side of the harness connector:
* The KS signal circuit, terminal A
* The KS signal circuit, terminal B
锟斤拷If less than the specified range, test the circuits for a short to ground or an open/high resistance. If the circuits test normal, replace the
ECM.
锟斤拷If greater than the specified range, test the circuits for a short to voltage. If the circuits test normal, replace the ECM.
9. Test for intermittent or poor connections at the ECM, KS, and in-line connectors where present.
10. If all circuits test normal, replace the ECM.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Knock Sensor 1 Replacement (See: Powertrain Management/Computers and Control Systems/Knock Sensor/Service and Repair/Knock
Sensor 1 Replacement)
* Knock Sensor 2 Replacement (See: Powertrain Management/Computers and Control Systems/Knock Sensor/Service and Repair/Knock
Sensor 2 Replacement)
* Engine Control Module Replacement (See: Powertrain Management/Computers and Control Systems/Engine Control Module/Service and
Repair)
* Engine Control Module Programming and Setup (See: Powertrain Management/Computers and Control Systems/Engine Control
Module/Testing and Inspection)
P0328
DTC P0324, P0325, P0326, P0327, P0328, P0330, P0332, or P0333
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC P0324
- Knock Sensor (KS) Module Performance
DTC P0325
- Knock Sensor (KS) Circuit Bank 1
DTC P0326
- Knock Sensor (KS) Performance
DTC P0327
- Knock Sensor (KS) Circuit Low Voltage Bank 1
DTC P0328
- Knock Sensor (KS) Circuit High Voltage Bank 1
DTC P0330
- Knock Sensor (KS) Circuit Bank 2
DTC P0332
- Knock Sensor (KS) Circuit Low Voltage Bank 2
DTC P0333
- Knock Sensor (KS) Circuit High Voltage Bank 2
Diagnostic Fault Information
