2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 525
* Module battery voltage must be between 9 - 16 V.
Conditions for Setting the DTC
The seat memory control module does not detect position sensor movement or pulse signals while the adjuster motor is active. The following
conditions will set this DTC:
B1825 01, B2355 01, B2365 01, or B2375 01
The seat memory control module detects a short to battery on the sensor signal circuit.
B1825 06, B2355 06, B2365 06, or B2375 06
The seat memory control module detects a short to ground or an open on the sensor signal circuit.
Action Taken When the DTC Sets
The seat memory control module disables the memory recall and easy exit/entry action commands of the motor monitored by the sensor. The motor
will respond to manual positioning commands.
Conditions for Clearing the DTC
* The current DTC clears when the fault is no longer present and the power mode changes to OFF then back to ACC or RUN.
* The history DTC will clear after 40 consecutive fault-free ignition cycles have occurred.
Reference Information
Schematic Reference
Driver Seat Schematics (See: Body and Frame/Seats/Diagrams/Electrical Diagrams/Driver Seat Schematics)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)
Description and Operation
Memory Seats Description and Operation (See: Body and Frame/Seats/Description and Operation/Memory Seats)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the appropriate driver seat motor listed below for which the DTC set:
* M50 seat front vertical motor
* M55 seat rear vertical motor
* M51 seat horizontal motor
* M56 seat back recline motor
2. Ignition ON, test for B+ between the 12 V reference circuit terminal 4 and ground.
瀚慖f less than the specified value, test the 12 V reference circuit for a short to ground or an open/high resistance. If the circuit tests normal,
replace the K40 seat memory control module.
3. Test for 0.3 - 2 V between the signal circuit terminal 2 and ground.
瀚慖f less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace
the K40 seat memory control module.
瀚慖f greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the K40 seat memory
