2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 450
Circuit/System Testing
1. Engine running, accessories OFF, measure and record the battery voltage at the battery terminals. The voltage should be between 12.6 and
15.0 volts.
瀚慖f not within the specified range, refer to Charging System Test (See: Starting and Charging/Testing and Inspection/Component Tests
and General Diagnostics/Charging System Test).
2. Ignition OFF, disconnect the harness connectors at the appropriate module.
3. Ignition OFF and scan tool disconnected, open and close the driver door, and wait 1 minute. Test for less than 5 ohms between the
appropriate ground circuit terminals listed below and ground.
* Terminal 5 (PPS)
* Terminal 13 (IPC)
* Terminal 8 X1 (amplifier, radio)
* Terminal 7 X2 (rear object)
瀚慖f greater than the specified range, test the ground circuit for an open/high resistance.
4. Verify that a test lamp illuminates between the appropriate B+ circuit terminals listed below and ground.
* Terminal 1 (IPC, PPS)
* Terminal 1 X1 (radio)
* Terminal 4 X1 (amplifier)
* Terminal 1 X2 (rear object)
瀚慖f the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
5. If all circuits test normal, replace the appropriate module.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Control Module References (See: Testing and Inspection/Programming and Relearning) for the appropriate module replacement, setup, and
programming.
B1335
DTC B1335
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC B1335 00
- Device Power 3 Circuit
DTC B1335 0B
- Device Power 3 Circuit Current Above Threshold
DTC B1335 42
- Device Power 3 Circuit Calibration Data Set Not Programed
DTC B1335 4B
- Device Power 3 Circuit Calibration Not Learned
Diagnostic Fault Information
