2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 463
瀚慖f less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace
the BCM.
6. If all circuits test normal, test or replace the headlamp and panel dimmer switch.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Headlamp Switch Replacement (Cadillac) (See: Lighting and Horns/Headlamp/Headlamp Switch/Service and Repair/Headlamp Switch
Replacement (Cadillac))Headlamp Switch Replacement (Except Cadillac) (See: Lighting and Horns/Headlamp/Headlamp Switch/Service
and Repair/Headlamp Switch Replacement (Except Cadillac))
* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, setup, and programming
Power Seats
DTC B1395
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC B1395 02
- Device Voltage Reference Output Circuit Short to Ground
DTC B1395 05
- Device Voltage Reference Output Circuit Short to Battery or Open
Diagnostic Fault Information
