2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 389
The radio is ON.
Conditions for Setting the DTC
Set by Radio
The radio sets a current status for this DTC when a short to ground, short to voltage or an open is detected on any of the speaker channel outputs
from the radio.
Set by Bose Amplifier
The DTC will not set during normal amplifier operation. The vehicle must have the ignition OFF for several hours and the fault must be present
during amplifier power-up.
DTC B1025 01, B1035 01, B1045 01, B1055 01, B1065 01, B1075 01, B1085 01, B1095 01
A short to voltage is detected on the specified (+) or (-) signal circuit
DTC B1025 02, B1035 02, B1045 02, B1055 02, B1065 02, B1075 02, B1085 02, B1095 02
A short to ground is detected on the specified (+) or (-) signal circuit
DTC B1025 04, B1035 04, B1045 04, B1055 04, B1065 04, B1075 04, B1085 04, B1095 04
An open is detected on the specified (+) or (-) signal circuit
Action Taken When the DTC Sets
No sound is present from one or more of the speakers.
Conditions for Clearing the DTC
Set by Radio
The fault condition becomes history if not present for 0.25 seconds.
Set by Bose Amplifier
The fault condition becomes history after the vehicle ignition has been OFF for several hours and then the ignition turns ON.
Diagnostic Aids
Speakers located in the front A-pillar are connected to the same channel as the speaker in the door. A DTC will only set after the amplifier only on
up-level radios.
Reference Information
Schematic Reference
Radio/Navigation System Schematics (See: Accessories and Optional Equipment/Diagrams/Electrical Diagrams/Radio/Navigation System
Schematics)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
