2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 381
Trouble Code Descriptions/Diagnostic Trouble Code (DTC) List - Vehicle)
2. With the scan tool observe the SDM impact sensor configuration scan tool data list. Verify the impact sensors called out in the scan tool data
list match the number of actual impact sensors the vehicle is built with.
瀚慖f the number of impact sensors do not match verify the correct SDM calibration file is loaded in the SDM.
瀚慖f the SDM calibration file is correct, the vehicle contains less/more sensors than it is supposed to. Modify the vehicle to match the SDM
impact sensor calibration scan tool data list.
3. With the scan tool observe the SDM enabled deployment loop configuration scan tool data list. Verify the enabled deployment loops called
out in the scan tool data list match the deployment loops the vehicle is built with.
瀚慖f the number of enabled deployment loops do not match verify the correct SDM calibration file is loaded in the SDM.
瀚慖f the SDM calibration file is correct, modify the vehicle to match the SDM enabled deployment loop calibration scan tool data list.
4. If the SDM impacts sensor and enabled deployment loops match the vehicle build and the DTC is still current, replace the K36 SDM.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* SIR/SRS Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Wiring Repairs/SIR/SRS Wiring Repairs)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for SDM replacement, setup, and programming
Vehicle Access
DTC B1019
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC B1019 00
- System Configuration Error
Circuit/System Description
When calibrating the liftgate position, the liftgate module (LGM) is placed in a functional state to learn the liftgate travel limits. DTC B1019 00
will set automatically as an indicator that the system is in learn mode and not as a fault indicator. Once the travel limits are learned by the LGM, the
liftgate module will exit calibration mode and DTC B1019 00 become a history code.
Conditions for Running the DTC
The system voltage is 9-16 volts.
Conditions for Setting the DTC
Whenever the LGM is replaced or in learn mode.
Action Taken When the DTC Sets
The power liftgate system will be disabled.
Conditions for Clearing the DTC
* The DTC will be current until the liftgate calibration procedure has been completed.
* When the calibration procedure has been completed the DTC will be a history DTC.
Diagnostic Aids
Setting B1019 00 is normal after flashing the liftgate module. This DTC will be current after flashing and the DTC will go to history after learning.
