2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 1770
Computers and Control Systems/Transmission Position Sensor/Switch/Service and Repair/2ML70 - Automatic Transmission).
* Transmission Control Wiring Harness Extension Harness Removal (See: Transmission and Drivetrain/Automatic
Transmission/Transaxle/Service and Repair/Overhaul/2ML70 - Automatic Transmission/5. Transmission Control Wiring Harness Extension
Harness Removal).
P16F5
DTC P16F5
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC P16F5
- Control Module Programmable Logic Device
Circuit/System Description
This diagnostic applies to internal microprocessor integrity conditions within the hybrid powertrain control module (HPCM). The HPCM and each
Motor Control Module (MCM) utilize a programmable logic device (PLD) to perform certain input and output functions. The HPCM monitors the
ability of the PLD to perform these functions.
Conditions for Running the DTC
* The control module runs the program to detect an internal fault when the key is ON.
* Ignition voltage is 8-18 volts.
Conditions for Setting the DTC
The control module has detected an internal PLD malfunction.
Action Taken When the DTC Sets
* DTC P16F5 is a Type A DTC.
* The HPCM commands the battery energy control module (BECM) to open the high voltage contactor relays.
Conditions for Clearing the DTC
DTC P16F5 is a Type A DTC.
Diagnostic Aids
An intermittent loss of battery power to the drive motor generator power inverter module assembly (PIM) may set this DTC.
Reference Information
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code
(DTC) Type Definitions)
Circuit/System Verification
1. Clear the DTC information.
2. Turn the ignition OFF for 1 minute.
3. Turn the ignition ON.
4. Retest for DTC P16F5.
Circuit/System Testing
1. Ignition OFF, disconnect the 12V battery. Refer to Battery Negative Cable Disconnection and Connection (See: Starting and
Charging/Battery/Battery Cable/Negative/Service and Repair/Battery Negative Cable Disconnection and Connection).
