2010 Cadillac Truck Escalade ESV AWD V8-6.2L Page 571
After a heated seat is activated, the HSM detects a shorted circuit on the seat heating element supply voltage circuit or control circuit.
B2345 13
Any of the temperature sensor inputs remains below 1.45 V for more than 1 second.
B2345 42
The current sensing calibration is not programmed.
B2345 4B
The current sensing calibration is out of range.
Action Taken When the DTC Sets
The heated seat function for both seats will be disabled.
Conditions for Clearing the DTC
* The current DTC clears when the malfunction is no longer present and the power mode changes to OFF then back to ACC or RUN.
* The history DTC will clear after 50 consecutive fault-free ignition cycles have occurred.
Reference Information
Schematic Reference
Heated/Cooled Seat Schematics ()
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Heated Seats Description and Operation (KA1) ()Heated Seats Description and Operation (KA6) ()
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Testing
B2345 00
1. Ignition OFF, disconnect the X1 harness connector at the HSM.
2. Test for infinite resistance between the control circuit terminal 3 and ground.
锟斤拷If not the specified value, test the control circuits listed below for a short to ground:
* Driver seat cushion and seat back element terminal 3
* Driver seat cushion element terminal 5
* Driver seat back element terminal 1
3. Test for infinite resistance between the control circuit terminal 6 and ground.
锟斤拷If not the specified value, test the control circuits listed below for a short to ground:
* Passenger seat cushion and seat back element terminal 6
* Passenger seat cushion element terminal 2
* Passenger seat back element terminal 4
4. Ignition ON, verify that a test lamp does not illuminate between the control circuit terminal 3 and ground.
