2010 Cadillac Truck Escalade ESV AWD V8-6.2L Page 1710
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning)for scan tool information
Circuit/System Testing
1. Ignition OFF, disconnect harness connector of the B47 fuel pressure sensor.
2. Ignition OFF, test for less than 1.0 ohm between the low reference circuit terminal 2 and ground.
锟斤拷If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the K27
fuel pump control module.
3. Ignition ON, test for 4.8-5.2 V between the 5 V reference circuit terminal 3 and ground.
锟斤拷If less than the specified range, test the 5 V reference circuit for a short to ground or an open/high resistance. If the circuit tests normal,
replace the K27 fuel pump control module.
锟斤拷If greater than the specified range, test the 5 V reference circuit for a short to voltage. If the circuit tests normal, replace the K27 fuel
pump control module.
4. If all circuits test normal, replace the B47 fuel pressure sensor.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Fuel Pressure Sensor Replacement (See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Pressure Sensor/Switch/Service and
Repair)
* Control Module References (See: Testing and Inspection/Programming and Relearning)for fuel pump control module replacement, setup,
and programming
P06B1
DTC P06B1, P06B2, P06B4, or P06B5
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC P06B1
- Sensor Positive Voltage Circuit 1 Low Voltage
DTC P06B2
- Sensor Positive Voltage Circuit 1 High Voltage
DTC P06B4
- Sensor Positive Voltage Circuit 2 Low Voltage
DTC P06B5
- Sensor Positive Voltage Circuit 2 High Voltage
Circuit/System Description
The drive motor generator power inverter module (PIM) contains two motor control modules (MCM) and a hybrid powertrain control module
(HPCM). The MCMs share an internal 15 volt reference power supply in order to operate the drive motor sensors processors. This fault is handled
inside the PIM and no external circuits are involved.
Conditions for Running the DTC
* The control module runs the program to detect an internal fault when the key is ON.
* Ignition voltage is 8-18V.
Conditions for Setting the DTC
