2010 Cadillac CTS Sedan AWD V6-3.6L Page 1693
瀚慖f greater than the specified range, test the 5-volt reference circuit for a short to voltage. If the circuit tests normal, replace the ECM.
4. Ignition ON, verify that the scan tool CPP sensor parameter is less than 0.1 volts.
瀚慖f greater than the specified value, test the signal circuit for a short to voltage. If the circuit tests normal, replace the ECM.
5. Install a 3A fused jumper wire between the signal circuit terminal B and the 5-volt reference circuit terminal C. Verify that the scan tool CPP
sensor parameter is between 4.8-5.2 volts.
瀚慖f less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace
the ECM.
6. If all circuits test normal, test or replace the CPP sensor.
Component Testing
1. Ignition OFF, disconnect the harness connector of the CPP sensor.
2. Measure the resistance between the signal terminal B and the low reference terminal A of the CPP sensor. Sweep the CPP sensor through the
entire range. The resistance should vary low to high and high to low without any spikes or dropouts.
瀚慖f the resistance is erratic with spikes or dropouts, replace the CPP sensor.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Clutch Pedal Replacement (See: Transmission and Drivetrain/Clutch/Clutch Pedal Assembly/Service and Repair/Clutch Pedal Replacement)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for ECM replacement, setup and programming
Tremec 6-Speed - Manual Transmission
DTC P0807 or P0808
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC P0807
- Clutch Pedal Position (CPP) Sensor Circuit Low Voltage
DTC P0808
- Clutch Pedal Position (CPP) Sensor Circuit High Voltage
Diagnostic Fault Information
Typical Scan Tool Information
